The Smart Home Glossary: Lighting, Wiring and Smart Home Terms Explained Simply

Plain-English definitions of 48 smart home, lighting and wiring terms Singapore homeowners meet in a renovation, from kelvin and coves to LEW and Matter.

By the Maxsen design team · Updated October 2026 · 9 min read

A marked-up floor plan, a colour temperature card, a downlight sample and a cup of kopi
Scene visualisationPlanning light points on the floor plan

This glossary explains, in plain English, the 48 lighting, wiring and smart home terms Singapore homeowners meet most often when planning a renovation, from kelvin and cove lighting to LEW, neutral wire and Matter. Each term has a short definition and a link to the Journal article that covers it in depth.

Key takeaways

  • Colour temperature and brightness are separate: kelvin describes how warm or cool light looks, while dimming sets how much light there is 1.
  • LED dimming problems are often caused by a mismatch between the dimmer and the LED, which is why terms such as driver, phase-cut and low-end trim matter when you plan 3.
  • In Singapore, electrical work in homes must be carried out or supervised by an EMA-licensed electrical worker (LEW) 6.
  • Many smart switches need a neutral wire at the switch box, so check for one early in an HDB renovation.
  • Matter, Thread and Zigbee describe how smart devices talk to each other; the CLS label tells you how well a device is secured.

Which terms will you hear at each stage of a renovation?

Most of these terms come up at a predictable point in a renovation, from a particular person. The table shows where to expect them, so you can read ahead.

StageUsually fromTerms to know
Design and ceiling planYour IDFalse ceiling, reflected ceiling plan, cove lighting, layered lighting, beam angle
Choosing fittingsID or lighting supplierColour temperature, kelvin, tunable white, tri-colour, CRI, IP rating
Wiring and switchesYour LEW or electricianCircuit, distribution board, neutral wire, RCCB, two-way switching
Dimming and controlYour smart home installerDriver, phase-cut, trailing-edge, low-end trim, scene
Connected devicesInstaller or retailerMatter, Thread, Zigbee, mesh network, CLS
Building rulesHDB or your MCSTLEW, EASE, HIP, MCST

Light and colour

  • Accent lighting: Focused light that picks out a feature such as artwork, a shelf or a textured wall. It is usually the dimmest layer in a room. See lighting artwork and feature walls.
  • Ambient lighting: The soft, even background light that lets you move around a room comfortably, often from a cove or evenly spaced downlights. See layered lighting.
  • Beam angle: The width of the cone of light a fitting produces. Narrow beams make defined pools of light; wide beams spread it more evenly. See downlights without glare.
  • Colour Rendering Index (CRI): A scale with a maximum of 100 that describes how faithfully a light source shows colours compared with a reference light source. Higher values make colours, food and skin tones look more natural. See lighting artwork and feature walls.
  • Colour temperature: How warm or cool white light looks, measured in kelvin. Lower values look warmer and more yellow, higher values cooler and bluer 1. See colour temperature, room by room.
  • Cove lighting: A concealed line of light set into a ledge in the ceiling or wall, so the light bounces off the surface instead of shining at you. See cove lighting.
  • Deep-set downlight: A recessed downlight whose light source sits well back inside the housing, hidden from most viewing angles, so it causes less glare. See downlights without glare.
  • Dim-to-warm: Lighting that lowers its colour temperature as it dims, mimicking the way incandescent bulbs turned amber 2. Warmth is tied to brightness, so the two cannot be set separately. See smart bulbs, tri-colour or control-first.
  • Glare: Discomfort, or loss of clear vision, caused by seeing a bright light source directly. It is worst when you look up from a sofa or bed. See downlights without glare.
  • IP rating: An Ingress Protection code, defined by the international standard IEC 60529, with two digits: the first for protection against solids such as dust, the second for water. See bathroom lighting and IP ratings.
  • Kelvin (K): The unit of colour temperature. Light at about 2200K–3000K resembles incandescent light, 3500K–4100K is a neutral white, and 5000K–6500K resembles daylight 1. See colour temperature, room by room.
  • Layered lighting: Combining ambient, task and accent light in one room, each on its own circuit so it can be switched and dimmed separately. See layered lighting.
  • Lux: A measure of how much light falls on a surface, equal to one lumen per square metre; a lumen measures the total light a source gives out. See work-from-home lighting.
  • Task lighting: Brighter, aimed light for an activity such as cooking, reading or homework. See kitchen lighting.
  • Tri-colour: Fittings with several sets of LED chips that switch between three fixed whites, commonly 3000K, 4000K and 6000K. They change in steps rather than smoothly. See smart bulbs, tri-colour or control-first.
  • Tunable white: Light whose colour temperature can be adjusted smoothly across a range rather than in fixed steps. Maxsen's spans 2700K–6000K as standard and 1800K–6000K with the premium Maxsen Tunable White upgrade. See from candlelight to daylight.

Dimming and control

  • 0–10V dimming: A dimming method that sends a separate low-voltage analogue control signal, between 0 and 10 volts, to the LED driver to set the light level. See dimmer types explained.
  • DALI: Digital Addressable Lighting Interface, the international standard for digital lighting control published as IEC 62386. Each fitting can be addressed and dimmed individually. See dimmer types explained.
  • Dimmer: A control that changes how bright a light is. With LEDs, the dimmer must be compatible with the fitting to dim smoothly 3. See dimmer types explained.
  • Driver: The electronics in or beside an LED fitting that convert mains power into the current the LEDs need. The driver largely decides how smoothly a light dims. See what makes dimming feel premium.
  • Drop-out: When an LED switches off before the dimmer reaches its lowest point, typically because it is being dimmed lower than it was designed for 4. See what makes dimming feel premium.
  • Flicker: A rapid, repeated change in light output, sometimes visible and sometimes only noticeable on a phone camera. It is measured partly as percent flicker, the depth of each pulse 5. See what makes dimming feel premium.
  • Halo: The Maxsen smart dimmer: turn the ring for brightness, turn the face for colour temperature, and press for scenes. See Halo, explained.
  • Leading-edge dimmer: A phase-cut dimmer that switches off the start of each half-cycle of mains power. It is the older, more common type, developed for incandescent bulbs. See dimmer types explained.
  • Low-end trim: The setting that fixes a dimmer's lowest level, so the light stays steady at the bottom of the range instead of flickering or dropping out 4. See what makes dimming feel premium.
  • Phase-cut dimming: Dimming by switching off part of each cycle of the mains supply, the method most wall dimmers use. It was developed for incandescent bulbs, so LEDs need compatible parts to dim well 3. See dimmer types explained.
  • Scene: A saved combination of lights, levels and colour temperatures recalled with one press, such as Morning, Dinner or Film. See designing lighting scenes.
  • Smart switch: A wall switch with built-in electronics that can run scenes and be controlled remotely, while still working as an ordinary switch for everyone at home. See why the switch comes before the bulb.
  • Trailing-edge dimmer: A phase-cut dimmer that switches off the end of each half-cycle of mains power. It generally suits the low loads of LED drivers better than leading-edge types. See dimmer types explained.
  • Two-way switching: Controlling the same lights from two or more places, such as both ends of a corridor or the door and the bedside. See two-way switching.

Wiring and installation

  • Circuit: A group of lights or sockets wired together and protected by one breaker at the distribution board. Each lighting layer needs its own circuit to be dimmed separately. See planning switch panels room by room.
  • Distribution board (DB): The panel of circuit breakers that feeds and protects every circuit in your home. See HDB electrical works and smart homes.
  • EASE: HDB's Enhancement for Active Seniors programme, which provides elderly-friendly fittings such as grab bars and slip-resistant treatment for bathroom floors. See a smart home for ageing parents.
  • False ceiling: A lowered ceiling, usually plasterboard, that hides wiring and aircon trunking and holds downlights and coves. Coves and downlight positions must be planned before it is built. See cove lighting.
  • HIP: HDB's Home Improvement Programme, which carries out essential improvements in older flats. See smart homes in resale HDB flats.
  • LEW: A Licensed Electrical Worker, licensed by the Energy Market Authority (EMA). EMA requires electrical work in homes to be carried out or supervised by one 6. See HDB electrical works and smart homes.
  • MCST: The Management Corporation Strata Title, the body that manages a condominium's common property and sets its by-laws, including renovation rules. See condo smart homes.
  • Neutral wire: The conductor that carries current back to the supply to complete a circuit. Many smart switches need one at the switch box to power their electronics, and many HDB switch boxes do not have one. See the no-neutral-wire question.
  • RCCB: A residual current circuit breaker, the safety device at the distribution board that cuts power when it detects current leaking to earth, for example through a faulty appliance or a person. See bathroom lighting and IP ratings.
  • Reflected ceiling plan: A drawing of the ceiling as if seen from below, showing downlights, coves, aircon and other fittings. Agree it with your ID before the false ceiling is built. See downlights without glare.
  • Smart distribution board: A distribution board designed to support energy monitoring and smart home features, fitted in HDB's smart-enabled flats in estates such as Punggol Northshore. See HDB smart-enabled homes.

Networks and security

  • CLS: The Cyber Security Agency of Singapore's Cybersecurity Labelling Scheme, which rates consumer smart devices from Level 1 to Level 4. See smart home security in Singapore.
  • Matter: An open smart home standard from the Connectivity Standards Alliance that lets certified devices from different brands work together. It runs over Wi-Fi, Thread or Ethernet. See Matter, Thread, Zigbee and Wi-Fi.
  • Mesh network: A network in which devices relay messages for one another, so a signal can hop around walls to reach its destination. Mesh Wi-Fi systems use several access points to cover a home. See Wi-Fi in concrete homes.
  • Thread: A low-power mesh network built on IPv6 and the IEEE 802.15.4 radio standard, often used to carry Matter. See Matter, Thread, Zigbee and Wi-Fi.
  • Thread border router: A device that connects a Thread mesh to your home's Wi-Fi or Ethernet network, often built into a smart speaker or hub. See Matter, Thread, Zigbee and Wi-Fi.
  • Two-factor authentication (2FA): A second check at sign-in, such as a one-time code, so a stolen password alone cannot open your account. See smart home security in Singapore.
  • Zigbee: A low-power mesh network, also based on IEEE 802.15.4 and developed by the Connectivity Standards Alliance, long used for lighting and sensors. See Matter, Thread, Zigbee and Wi-Fi.

Maxsen designs and installs smart homes in Singapore with its own team: planned with you, installed, and handed over working.

Sources

  1. "Color and Mood." ENERGY STAR, US Environmental Protection Agency. energystar.gov
  2. "Color Tuning with Lutron Controls." Lutron Application Note #579, 2021. assets.lutron.com
  3. "DOE Publishes New Report on Dimming LEDs with Phase-Cut Dimmers." US Department of Energy, 2013. energy.gov
  4. "Flickering/Flashing LED Lights with Maestro Dimmers." Lutron Electronics. support.lutron.com
  5. J. Brodrick, "Flicker: Understanding the New IEEE Recommended Practice." US Department of Energy, 2015. energy.gov
  6. "Engaging Licensed Workers." Energy Market Authority. ema.gov.sg
Talk to us

Discover a smarter way to feel at home.

Tell us about your home. We will visit, listen, and propose a home composed in light.